Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-1259VC-BD
3
c. Transient communication problems exist between the switch and this
circuit pack. Execute the
test board PCSS
command and refer to the
repair procedures for the Control Channel Loop Around Test (#52).
d. The circuit pack detected an on-board hardware failure. The reported aux
data values correspond to the following detected errors:
Reset the circuit pack by executing the
busyout board PCSS,
reset
board PCSS
, and
release board PCSS
commands. When it is reset, the
circuit pack executes a set of tests to detect the presence of any of the
above faults. The detection of one these errors during initialization causes
the circuit pack to lock-up and appear insane to the system. See the repair
procedures in footnote (a) for error type 1.
e. The circuit pack detects a program logic error. While no action is required,
this error may lead to errors of other types being reported against this
circuit pack.
f. The circuit pack cannot update NPE memory and read it back. This error
type can be ignored, but it may lead to other error types being reported
against this circuit pack.
g. A critical hardware failure has been detected on the circuit pack. Use
busyout board PCSS
,
reset board PCSS
, followed by
release board
PCSS
. If test #53 passes, the on-board circuitry is healthy. Use
test board
PCSS long clear
to retire the alarm. If test #53 fails, replace the circuit
pack.
h. The circuit pack detected a critical hardware failure. Reset the circuit pack
by issuing the
busyout board PCSS
,
reset board PCSS
, and
release
board PCSS
commands. If the Circuit Pack Restart Test (#594) passes,
then the on-board circuitry is healthy. Retire the alarm by issuing the
test
board PCSS long clear
command. If the Circuit Pack Restart Rest (#594)
fails, replace the circuit pack.
The reported error types correspond to the following detected errors:
Error Description
4352 External RAM error
4353 Internal RAM error
4355 ROM Checksum error
4357 Instruction set error
Error Description
1293 On-board auxiliary processor insane
1294 Internal memory access error