Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-340test hardware-group
2
test hardware-group
This command allows a user to perform a set of hardware diagnostic tests on the
whole system, a carrier, cabinet, spe, or board. The tests vary according to the
configuration of the system and the specified command options. Each test
exercises diagnostics on all the hardware in the specified hardware group and
reports results of the test along with any possible error codes. Concurrent testing
is done to enhance performance, therefore, test results display on the SAT in the
order they are received. Consequently, test results of one maintenance object
may be intermixed with test results of other maintenance objects.
Because the tests for this command are not destructive, the tests performed on a
particular maintenance object with either the
short
or the long
option
may not be
the same as the corresponding demand tests.
A hardware-group command executing in the foreground
may be cancelled by
either pressing the
CANCEL key or by entering the
cancel hardware-group
command at a different SAT. However, if the technician wants to cancel a
test
hardware-group
command running in the background
, the
cancel
hardware-group
command can be entered on any SAT. A canceled
test
hardware-group
command can be resumed at the point it left off by entering the
resume hardware-group
command. Restarts are not allowed for
test
hardware-group
commands entered with either the
all-ports
option or the
spe-interchange
option.