DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-329CARD-MEM (Memory Card)
3
a. Remove the memory card from the Processor circuit pack.
b. Replace the Processor circuit pack. Follow the standard
procedures.
c. Insert the memory card back into the slot at the Processor circuit
pack.
d. Enter the
test network-control [long]
command to verify the new
circuit pack and the memory card.
5. Once the alarm is resolved, enter the
save translation
command to store
the current system translations to the memory card.
6. If applicable, enter the
save announcements
command to store the
current announcements to the memory card.
Save Translations Interference
All of the actions used in DEFINITY R8 administration commands are listed in the
table below. The command actions that, while active, interfere with daily
maintenance are also indicated. They are the
add
,
change
,
duplicate
,
remove
,
and
set
commands. These commands are frequently used by customer
administrators while performing routine administration of DEFINITY.
Table 3-143. DEFINITY Command Actions
Likely to
Disrupt
Less Likely to
Disrupt
add backup ping
change busyout recycle
duplicate clear release
remove display reset
set enable restore
format resume
get save
list status
mark test
monitor upgrade
netstat
Continued on next page