Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance for csi systems
1-51Troubleshooting Features
1
2. Dial the 6-digit port number
PCSSpp
:
3. Listen for one of the following tones:
■ Confirmation Tone—touch-tone (DTMF) receiver is connected. Go
to Step 4.
■ Reorder Tone—touch-tone (DTMF) receiver is busy.
■ Intercept Tone—a touch-tone (DTMF) receiver or trunk has not been
accessed.
4. Dial
1234567890*#
and listen for Confirmation tone (test passed) or
intercept tone (test failed). The test fails if the touch-tone (DTMF) receiver
does not recognize all the touch-tone (DTMF) signals.
5. To test another touch-tone (DTMF) receiver, repeat Steps 2 through 4.
6. To terminate the test call, hang up the station set used for testing.
Time Slot Test Call
The time slot test call connects the voice terminal user to a specific time slot
located on the TDM Buses (A or B) or out-of-service time slots. Specific Time
Slots To place the call:
1. Dial the Facility Test Call Feature Access Code (for example, 197, see
Note), and listen for dial tone.
NOTE:
The Feature Access Code (FAC) is administered on the Feature
Access Codes Form. The 197 FAC code used here is an example.
2. Dial port network number (1), then press
# and the 3-digit time slot number
“sixty,” where:
3. Listen for one of the following tones:
■ Confirmation Tone—time slot is idle or maintenance busy
■ Reorder Tone—time slot is busy
■ Dedicated Tone—One of the following tones is heard (see
Table
1-4)
P = Port network number (1)
C = Carrier number (A=1, B=2, C=3)
SS = Slot number (01-10)
pp = Touch-tone (DTMF) Receiver Port number (01, 02, 05, or 06)
xxx = Time slot number (000 through 255 on Bus A and 256
through 511 on Bus B)