Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance for csi systems
1-22Initialization and Recovery
1
Reset System 1 (System Warm Start)
This recovery takes about 30 seconds. All stable phone calls remain up.
In-progress calls are dropped. No new calls can be made during this time.
In this restart, all software (Oryx/Pecos, drivers, maintenance, and so forth.) is
reset and the following displays:
RESET 1 (WARM) PERFORMED
Reset System 2 (System Cold Start
Without Translations Loading)
In this restart, all software (Oryx/Pecos, drivers, maintenance, and so forth) is
reset. In addition, the TDM Bus and all port circuit packs are reset. All Port circuit
packs are reset. All telephone sessions are dropped. Telephones begin to
reconnect to the switch within 30 seconds. In a large system, reconnection of all
telephones may take up to five minutes. Typical displays are:
INTERNAL REGISTER TEST PASSED
LOCAL BUS TEST PASSED
ROM CHECKSUM TEST PASSED
CONTROL STATUS TEST PASSED
DCACHE TEST PASSED
ICACHE TEST PASSED
WRITE BUFFER TEST PASSED
BTO TEST PASSED
TIMER TEST PASSED
RESET 2 (COLD_2)PERFORMED
Reset System 3 (System Cold Start
With Translations Loading)
In this restart, all software (Oryx/Pecos, drivers, maintenance, and so forth) is
reset. After the software is reset, all translations load from translation card. In
addition, the TDM Bus and all port circuit packs are reset. Emergency Transfer is
invoked. Translations reload from translation card. Depending on the translations,
the reloading process could take from five to 30 seconds. Thereafter, all port
circuit packs are reset, and all telephone sessions drop. Telephones begin to
reconnect to the switch within 30 seconds. In a large system, reconnection of all
telephones may take up to five minutes. Typical displays are as follows:
INVOKING EMERGENCY TRANSFER
INTERNAL REGISTER TEST PASSED
LOCAL BUS TEST PASSED
ROM CHECKSUM TEST PASSED
CONTROL STATUS TEST PASSED
DCACHE TEST PASSED
ICACHE TEST PASSED