Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-912PKT-INT (Packet Interface)
3
Reset Test (#889)
The reset action initializes the Packet Interface and causes the Packet Interface
firmware on the TN798 Processor circuit pack to run a comprehensive set of
diagnostic tests.
The demand reset action aborts if the specified Packet Interface is in the
in-service state.
A Packet Interface is put in the out-of-service state automatically if it has been
reset 4 times by background maintenance within the last 15 minutes,
independent of the results of the reset action.
256
512
768
FAIL
(cont’d.)
If error code 512 or 768 is reported for a Packet Interface, the receive
FIFO in the Packet Interface has overflowed. This may be an
indication that additional Packet Interface capacity is required. For
the current hardware configuration, only two Packet Interfaces are
provided, so the problem should be escalated if the following repair
steps do not correct the problem:
1. Retry the command after a one minute delay, and if the test
continues to fail, replace the TN798 Processor circuit pack at a
time that would cause the least service disruption.
PASS The system software is able to communicate with the Packet Interface. If
problems are still reported on the Packet Interface, check for failures using
the Private Looparound test (#885) and Maintenance Looparound test
(#886).
Table 3-391. TEST #887 Read and Clear Board Counters — Continued
Error
Code
Tes t
Result Description/ Recommendation
Continued on next page