Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-801MEDPRO (Media Processor MAPD Circuit Pack)
3
IP Address Query Test #1371
This test is destructive.
The Media Processor has two interfaces for configuring the board, through the
NT PC interface and the SAT via CCMS messages. For R8 DoLAN, the SAT and
CCMS are the only approved interface. However, the NT PC interface cannot
easily be disabled. It is possible that changes can be made via the NT PC
interface that cause the Media Processor board to be inconsistent with DEFINITY
translation. The area of concern is the IP address, subnet mask, and gateway
translation.
This test sends the Media processor the IP address, subnet mask, and gateway
translation (IP parameters). If the parameters do not match DEFINITY translation,
the new values are written into the Windows registry, and the NT PC asks the
maintenance sub-system to reboot the board. The board goes through a physical
board removal and insertion.
When this test fails, it is an indication that an illegal change was made and the
customer should be notified. Also, writing the IP address parameters to the
registry requires NT to reboot. If the IP addresses match, there is no need to
update the registry and reboot NT
Table 3-345. TEST #1371 IP Address Query Test
Error
Code
Te s t
Result Description/ Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The IP address, subnet mask, and gateway translation parameters do not
match DEFINITY translations. After the new values are written into the
Windows registry, the NT PC must go through a reboot. The board goes
through a physical board removal and insertion.
1. If the problem persists, replace the circuit pack.
PASS Translation data matches the Windows Registry.
Continued on next page