Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-152ATM-EI (Expansion Interface Circuit Pack)
3
1. Test the ATM-EI circuit pack (
test board UUCSS
) and investigate
further based on each test’s results. If all tests pass, the error was a
transient problem.
1088 or
1104
ATM-EI circuit pack received a request with an
invalid connection identifier.
Firmware-detected
problems on the ATM-EI
circuit pack. Note: Error
Types 1088-1103 are
reported by the board
that is originating the
connection. Error Types
1104-1119 are reported
by the board that is
terminating the
connection. In most
cases, when the
teminating board reports
one of these errors, the
originating board will also
report an ATM-NTWK
error for the same event
(usually with Error Type
21).
1089 or
1105
ATM-EI circuit pack received a request with a
reference to an unknown VC token.
1090 or
1106
ATM-EI circuit pack did not have enough
resources (memory) for the requested operation.
1091 or
1107
Internal failure in the local protocol stack. This
can occur when the connection to the ATM
switch failed, perhaps because the:
■ ATM switch rebooted
■ fiber between the ATM switch and the
ATM-EI circuit pack disconnected
1092 or
1108
ATM-EI circuit pack received a request for which
the referenced VC was in the wrong call state.
1093 or
1109
ATM-EI circuit pack received a request for which
the VPI/VCI pair was invalid or out of range.
1094 or
1110
ATM-EI circuit pack received a request to add a
party to an existing VC. The add party request
failed, and a retry was not possible.
1095 or
1111
ATM-EI circuit pack in link recovery after the
lower ATM layer (Q.SAAL portion of the protocol
stack) failed. This can occur when the connection
to the ATM switch failed, perhaps because the:
■ ATM switch rebooted
■ fiber between the ATM switch and the
ATM-EI circuit pack disconnected
1096 or
1112
ATM-EI circuit pack received an error from the
local protocol stack for which no more detailed
cause was specified.
1102 ATM-EI circuit pack asked to create more
connections that it was capable of creating.
1103 ATM-EI circuit pack detected an illegal message
from software.
1. Check the Error Log for CONN-M proc errors
for more information.
1113 Problems detected by the
board terminating the
connection
Table 3-63. ATM Error Types 1024 - 1151 — Continued
Error
Type Description General problem
Continued on next page