DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Commands
2-198reset packet-interface
2
For troubleshooting, see
‘‘status interface’’
,
‘‘status link n’’
, and
‘‘status
processor-channel’’ commands to locate problems before performing a
reset
interface
(link traffic is interrupted).
!
WARNING:
The interface command interrupts operation of the AP, DCS, AUDIX, CMS or
ISDN-PRI.
reset packet-interface
The IO-Processor controls the one and only Packet-Interface. To reset the
Packet-Interface for R6csi, use the
reset io-processor
command. Because this
command is not used in this software release, the following error message
displays on the status line:
Command unavailable; use ‘reset io-processor’
reset switch-control
This command resets and initializes the switch control hardware and firmware.
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
reset interface
location
(cabinet-carrier-position) of the
processor interface (PI board). The
position determines cleared
processor interface circuit pack.
first processor interface = 1
second processor interface = 2
init
inads
craft
none none
Action/Object Qualifier Qualifier Description Permissions Defaults
Feature
Interactions
reset
switch-control
none none init
inads
craft
nms
none