Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance for csi systems
1-44System Backup
1
Save announcements
Enter the
save announcements
command to save the recorded announcements
in the system on the translation card.
NOTE:
This command is not necessary for the TN750C Announcement circuit
pack.
NOTE:
A 10 MByte or larger translation card formatted for announcements (and/or
translations) is required to save and restore announcements. For more
information on formatting the translation card, see
‘‘format card-mem’’
in
Chapter 2, ‘‘Maintenance Commands’’
.
The system takes about 40 minutes to complete this task. Because the terminal is
unavailable during this time, it is recommended that this command be used after
business hours. During this time period, the terminal cannot be used to
administer the system until the save is complete; however, all other terminals (if
provided) are allowed to perform administration procedures.
Enter the
restore announcements
command to restore the recorded
announcements from the translation card back into system memory. The system
takes about 40 minutes to complete this task. After completing the task, the
system performs an audit to make sure that the announcements on the
announcement circuit pack match the announcements administered in the
system.
The working copy of the announcements is stored on the announcement circuit
pack. A backup copy should be made on a 10 MByte or larger translation card.
The following procedure is used to make a backup translation card:
1. Remove the translation card from the Processor circuit pack.
2. Insert the backup translation card into the Processor circuit pack.
3. Enter the
save announcement
command and press
Enter. This instructs
the system to take all announcement information in memory and transfer it
to the translation card. When finished, the following display appears: