Filter
Top Products
DEFINITY ECS Release 8.2 Maintenance for R8.2csi
555-233-119 Issue 1
April 2000
Maintenance Objects
3-336CARD-MEM (Memory Card)
3
System Technician-Demanded Tests: Descriptions
and Error Codes
Always investigate tests in the order presented in the table below. By clearing
error codes associated with the
Memory Card Insertion Test
for example, you
may also clear errors generated from other tests in the testing sequence.
Note:
a. Refer to 12V-PWR (12 Volt Power Supply) Maintenance documentation for
a description of this test.
Memory Card Erase/Write/Read Test (#693)
The purpose of this test, which is nondestructive, is to verify the erase, write, and
read operations. The test erases the backup copy of the translation file stored in
the memory card, and it verifies that the erase operation works. The test then
writes the primary copy of the translation file from the same memory card to the
erased flash segment, and it verifies that the translation file is written
successfully.
This test can be initiated through a system technician demanded
test card-mem
long
command, or it can be executed as part of a maintenance test sequence
when the
save translation
and
save announcements
operations fail. The test
Table 3-145. System Technician-Demanded Tests: CARD-MEM
Order of Investigation
Short Test
Sequence
Long Test
Sequence
Reset Board
Sequence D/ND
1
1. D = Destructive; ND = Nondestructive
12 Volt Power Supply Test (#701) (a) X X ND
Memory Card Insertion Test (#695) X X ND
Memory Card Format and Read Test (#696) X X ND
Memory Card Match Test (#697) X X ND
Memory Card Write-Protected Test (#698) X X ND
Memory Card Directory Recovery Test (#699) X X ND
Memory Card Translation Data Integrity Test
(#694)
XND
Memory Card Erase/Write/Read Test (#693) X ND
Continued on next page